• $2,500 Standard Shelf: 19" x 15" x 1.4" (WxDxH)
• $2,800 Standard Shelf: 21" x 16" x 1.4" (WxDxH)
• $3,200 Standard Shelf: 21" x 20" x 1.4" (WxDxH)
• $3,700 High LaMusika: 21" x 20" x 1.8" (WxDxH)
• $2,800 Violon Size: 15.8" x 20.7" x 1.4" (WxDxH)
• $4,000 Campanile Size: 16.5" x 28.9" x 1.4" (WxDxH)
Recognition
All powered electronics within a device are producing electromagnetic vibrations. Depending on the design and material of the devices, these vibrations have a greater or lesser degree of effects in the form of mechanical resonances.These resonances will reduce perfect operation of the electronics, such as transistors, valves, resistors, boards, high frequency coils, power supplies etc.Therefore, HiFi components will show the following effects: limited dynamics, non-transparent sound reproduction at lower volumes. Inaccurate reproduction of impulses at higher volumes; limited soundstaging and imaging, balance inaccuracy of the stereo signal will result in the lack of a definite center between the loudspeakers.
The solution
Depending on the design of your components and the possibility of a "coupling", Acapella bases "Fondato Silenzio" can eliminate the above described effects and will optimize the sonic performance of your HiFi system. Due to the reduced electromagnetic distortions, sound reproduction of your components will be more lively, more three-dimensional,cleaner and, at low volumes, much more transparent.
The result
If we assume that all components of your HiFi system have been optimized by using Acapella’s bases, then you will have a sound experience that is only comparable with the three-dimensional reproduction of live music: a holographic event.
The function
The above mentioned resonances of the electronics are transmitted to the boards. Through the fixings of the boards, these resonances can cause vibration of the casings. At this point, Acapella’s base gets its full damping effect. The resonances will be diverted to the aluminum surface via three aluminum pucks (now available "new" improved LaMusika Pucks. From this surface, the resonances go immediately into layers of plumb and felt and will finally be eliminated within a layer of finest quartz sand. The better the device is coupled with the base, the greater the desired effect.
Variations
In the regular case, the devices should be placed on the base with three pucks in-between. It is also possible to place the base with the pucks in-between upside down on the top side of the device. Another base design, made of two damping metal layers, can be placed between two devices. Damping factor of the base is also guaranteed without the pucks, but we recommend to use them for best performance.
Application
Begin to optimize performance with the amplifier(s) first, followed by the preamp and the CD-player or CD transport last. A positive effect is also given when you use "Fondato Silenzio" as the bases for your loudspeakers.
|
